Product Description

E27 DIY Festoon Lamp holder in black plastic is a re wire-able ES lamp holder specifically designed for our commercial grade flat rubber festoon cable.

Two spikes are made to pierce the flat rubble cable to make the lamp live. Careful attention should be observed to make all center pin terminals active cable (brown). The back plate is screwed on the make the pins pierce the cable.

Waterproofing is assured by the inclusion of a special seal between the body and the screw on back plate. Rated IP44 with rubber globe seal included.

These can be used at mains voltage or low voltage where required.

Fixing holes on the base allow for fixing to suitable structure or cable tie to catenary cable for longer runs un-supported.